Audix ADX40 Microphone

About Audix ADX40 Microphone

Audix ADX40 Microphone by Sam Ash - The ADX 40 is a miniature pre polarized condenser microphone designed to hang from an overhead position for applications in professional live sound, music, and broadcast. Available with a choice of three optional interchangeable microphone capsules cardioid, omni, and hypercardioid, the ADX 40 is most commonly used for plays, theatrical productions, choirs, group vocals, and room ambience miking. With a smooth uniform response over a frequency range of 40 20k Hz, the ADX 40 provides a warm, rich sound not typical of microphones this size. It is machined from solid brass and comes in a non reflective black finish. Supplied with an attached 30 cable, the ADX 40 operates on phantom power 9 52volts with the preamp module provided APS 910. If phantom power is not available, there is an optional power supply APS 911 that operates in phantom or battery mode with bass roll off and on off switches. Low noise electronic circuitry, low impedance, and balanced output allow interference free performance even with long cable runs. Applications Choirs, musical groups School plays, theatrical productions Room ambience microphone for recording or broadcast Orchestra Specifications Transducer Type Condenser pre polarized Frequency Response CardioidHypercardioid 40Hz 20kHz Omni 20 18kHz Polar Pattern cardioid, omni, hypercardioid depending on choice of capsule Output Impedance 250 Ohms balanced Open Circuit Sensitivity Cardioid Hypercardioid 5.2 mV Omnidirectional 4.1 mV Equivalent Noise Level 29 dB A weighted Signal to Noise Ratio 65 dB ref 1k 1 Pascal Power Requirements 9 52v phantom Maximum SPL 130dB CableConnector Shielded 30 14m terminating to a miniature 3 pin Switchcraft XLR connector TA3 f Polarity Positive voltage on pin 2 relative to pin 3 of output XLR connector Housing Machined Brass Weight 4 oz110 grams not including cable
Close...

Close...

Related Products