DrumZa

Crown MA 5002VZ Power Amplifier

 

Crown MA 5002VZ Power Amplifier

Crown MA 5002VZ Power Amplifier

Crown MA 5002VZ Power Amplifier

Crown MA 5002VZ Crown MA 5002VZ The Macro Tech and Maro Tech 02 Series high technology amplifiers designed specifically for professional sound reinforcement. MA Series amps provide enormous power in a low profile design. All Macro Tech Series amplifiers features PIP Programmable Input Processor technology, IOC InputOutput Comparator circuitry, Output Device Emulation Protection Circuitry ODEP and a Three year, No Fault, fully transferable Warranty. The following applies to 120 VAC, 60 Hz units in
Stereo mode with 8 ohm loads and an input sensitivity of 26 dB gain unless otherwise specified. Specifications for units supplied outside the U.S.A. may vary slightly at different AC voltages and frequencies. Power Load Impedance Safe with all types of loads. Rated for 2 to 8 ohms in Stereo, 4 to 16 ohms in Bridge Mono and 1 to 4 ohms in Parallel mono mode. Voltage Gain to 1 kHz, 8 ohm rated output; 1321 6 or 42 dB 1 dB gain at 0.775 volt sensitivity. 711 12 or 37 dB 1 dB gain at 1.4 volt sensitivity. 201 3 or 26 dB 0.25 dB gain at the 26 dB gain setting. Required AC Mains 50 or 60 Hz; 100 , 120 , 200 , 208 , 230 , 240 VAC 10. AC Line Current, Current, voltage and frequency requirements are provided on the units back panel. At Idle All units draw 90 watts or less. AC Line Connector 10 AWG cordset with NEMA TT30P plug is provided on 120 VAC, 60 Hz North American units. Crown MA 5002VZ Features Performance Frequency Response 0.1 dB from 20 Hz to 20 kHz at 1 watt. Phase Response 10 degrees from 10 Hz to 20 kHz at 1 watt. Signal to Noise Ratio,A weighted Better than 105 dB below rated 1 kHz power. Total Harmonic Distortion THD 1 kHz rated power, 0.05 or less true THD. Intermodulation Distortion IMD 60 Hz and 7 kHz at 41 Less than 0.05 from rated power to 35 dB below rated power at 8 ohms. Damping Factor Greater than 1,000 from 10 Hz to 400 Hz. Controlled Slew Rate Slew rates are limited to useful levels for ultrasonicRF protection. Greater than 30 volts per microsecond. Controls Compressor A three position back panel switch is used to control each channels input compressor. The fast setting provides an attack time of 4 milliseconds and a release time of 300 milliseconds; the slow setting provides an attack time of 12 milliseconds and a release time of 600 milliseconds; the off setting defeats output driven compression. Enable A front panel push button used to turn the amplifier on and off. Input Ground Lift A two position back panel switch located on the PIP2 FXQ used to isolate the input audio signal grounds from the AC chassis ground. Level A front panel rotary potentiometer for each channel with 31 detents used to control the output level. Loudspeaker Offset Integration A two position back panel switch for each channel used to turn the loudspeaker protection circuitry on and off. The circuitry protects against DC, off center woofer cone movement, and unwanted subsonic and ultrasonic
Close...
Price:  $4299.00
Check Availability

Review Crown MA 5002VZ Power Amplifier

 Your Rating Your Comments (optional)




Your review will appear on DrumZa after it has been approved. Thank you for your contribution.

Close...
More Crown
More Power Amplifiers
More Crown Power Amplifiers
 Product Name
 Crown MA 5002VZ Power Amplifier
Related Products